innovative
progressive
reliable

«PeakTech® P 3350» TrueRMS digital multimeter ~ Auto. Range ~ 6.000 Counts ~ 600 V / 10 A AC/DC

€44.90*

This product will be released on 9 August 2021

Product number: P 3350
EAN: 4250569406218
Product information "«PeakTech® P 3350» TrueRMS digital multimeter ~ Auto. Range ~ 6.000 Counts ~ 600 V / 10 A AC/DC"
The new PeakTech 3350 was specially developed for use in the craftsmanship and industry and offers a variety of useful functions that simplify daily work, especially in dark or noisy environments. The lighting of the large LCD display is automatically activated by a photodiode in dark surroundings. On the back of the device there is also a bright LED flashlight, which is used to illuminate the area where the measurement has to be taken. A multi-colored LED bar is located above the 6000-digit display. Depending on the active measuring function, it lights up green during the continuity test, red when a voltage is found in NCV mode, yellow when measuring large capacities or flashes red when the phase tester mode is active (LIVE). The PeakTech 3350 was manufactured according to the latest development aspects and has a double-insulated injection-molded housing with rubber coating, a tilt stand on the back, which can be removed to replace the batteries. The fuses are located underneath the stand as well, if it is neccessary to replace these. With this device the measuring range is selected automatically, which enable particularly fast response times.
Basic Accuracy DC: +/- 0,5%
Battery: 1,5V AAA
Capacitance max.: 60 mF
Digital counts: 6.000
Display Type: LCD
Info-LEDs:
LED-lamp:
NCV:
Over voltage category: CAT III 600 V
Range selection: Auto
True RMS:
V DC max.: 600V
A AC max.: 10A
Hz max.: 10 MHz
OHM max.: 60 MΩ
Temp. max.: 1000 °C
Temp. min.: -18 °C
mA DC max.: 600mA
mV DC max.: 600 mV
µA DC max.: 6000 µA
V AC max.: 600 V
mV AC max.: 600 mV
A DC max.: 10A
mA AC max.: 600 mA
µA AC max.: 6000 µA
  • True RMS voltage up to 600 V and current up to 10 A AC / DC
  • 6,000 LCD display with automatic backlight
  • Multi-colored warning LED for various measuring functions
  • Automatic range selection
  • Manual range selection possible using selection buttons
  • Integrated LED flashlight for lighting the area where the measurement has to be taken
  • Auto off and battery status display
  • Safety: EN 61010-1; CAT III 600 V
  • Accessories: bag, test leads, temperature sensor, temperature adapter, batteries and user manual
«PeakTech® P 8200» Measuring Accessories Set
This extensive collection of test accessories for the electronics area provides the best suitable measuring adapter for the desired application for each digital multimeter. In addition, these high quality clips and cables are all manufactured to the latest safety standards and provides a high safety in every application for the user. For the material, a flexible plastic was chosen, which can also withstand the hardest kinds of usage.

€37.40*

«PeakTech® P 7000» Tapping clamps for Digital Multimeter up to 10 A
These measuring accessories with 4 mm sockets can be connected to almost all measuring devices. Thanks to its hook-shaped alligator clips, it is possible to carry out measurements even in hard-to-reach points on a circuit. A maximum of safety is achieved by the double insulation of the lines and the protection against accidental contact with conductive metal parts when closed. This makes these accessories ideal for use in training and service.

€13.50*

«PeakTech® MKS-10» Measuring tip set with 1 mm test tips
This measuring tip set for all standard measuring lines with 4 mm safety sockets was developed in order to be able to measure even small components precisely. This measuring tip set also includes the matching alligator clips, that it is possible to fix the measuring tips to the component to be measured. When using the measuring tips without the alligator clips, an overvoltage category of CAT I 1000 V is guaranteed. By using the alligator clips, it is possible to use the overvoltage category CAT III.

€9.95*

«PeakTech® P 7005» Test Leads for Digital Multimeter with extension
This measuring accessorie with 4 mm sockets can be connected to almost all measuring devices and power supplies. With the extension adapters, it is possible to connect the test leads to other test leads in order to carry out measurements over long distances. The safety of these measuring wires is ensured by the double insulation of the lines and the contact protection against conductive metal parts. This makes these accessories ideal for use in training and service.

€7.00*

«PeakTech® P 7015» Alligator clamps for Digital Multimeter
The alligator clips enable safe measurements even on bare or exposed cables. With their 4 mm sockets, they can be used for almost any multimeter and measuring device. A maximum of safety is achieved by the protection against against accidental contact with conductive metal parts. This makes these accessories ideal for use in training and service.

€7.00*

«PeakTech® TKS-4» Test Leads with 4 mm spring-contact probe tip
This test cable set for multimeters consists of safety test leads in accordance with the EN 61010-031 standard with 4 mm safety sockets in a robust design with a cable length of 120 cm and 90 ° angled plugs. The 4mm diameter spring contact test probes of the TKS-4 cables fit exactly into power sockets and are provided with removable protective caps. In CAT I / CAT II measurement environments, these can be accepted for a probe tip length of 18mm, in CAT III / CAT IV measurement environments they must remain attached for better user safety and provide a probe tip length of 4mm.

€6.60*

«PeakTech® TKS-8» Test Leads with 2 mm probe tip and sleeves
This test cable set for multimeters consists of safety test leads in accordance with the EN 61010-031 standard with 4 mm safety sockets in a robust design with a cable length of 120 cm and 90 ° angled plugs. The 2mm diameter test probes of the TKS-8 cables are provided with removable protective caps. In CAT I / CAT II measurement environments, these can be accepted for a probe tip length of 18mm, in CAT III / CAT IV measurement environments they must remain attached for better user safety and provide a probe tip length of 4mm.

€6.10*

«PeakTech® P 7010» Tapping clamps for Digital Multimeter; 5 A
This measuring accessory with 4 mm sockets can be connected to almost all measuring devices and power supplies. Thanks to the fine alligator clips, even measurements on small components or at hard-to-reach points on circuits are possible. A maximum of security is achieved by the double insulation of the wires and the protection against accidental contact with conductive metal parts when closed. This makes these accessories ideal for use in training and service.

€5.50*

«PeakTech® P 7020» Test Leads for Digital Multimeter
This measuring accessorie with 4 mm sockets can be connected to almost all measuring devices and power supplies. A maximum of safety is achieved by the double insulation of the wires and the protection against accidental contact with conductive metal parts when closed. This makes these accessories ideal for use in training and service.

€4.70*

«PeakTech® P 7025» Test Leads for Digital Multimeter with coupling
These test leads with 4 mm sockets have a coupling, which makes it possible to connect other test leads to them. The safety of these measuring wires is ensured by the double insulation of the lines and the contact protection against conductive metal parts. This makes these accessories ideal for use in training and service.

€4.30*

«PeakTech® TKS-5» Testkabelsatz für Digital-Multimeter, PeakTech 3355/3360, TKS-5
Dieser Testkabelsatz für Multimeter besteht Sicherheitsprüfleitungen entsprechend der Norm EN 61010-031 mit 4 mm Sicherheitsbuchsen in robuster Bauform mit einer Kabellänge von 120 cm und 90° Winkelstecker. Die 2mm Durchmesser Prüfspitzen der TKS-5 Leitungen sind mit abnehmbaren Schutzkappen versehen. In CAT I / CAT II Messunmebungen können diese für eine Prüfspitzenlänge von 18mm abgenommen werden, in CAT III / CAT IV Messumgebungen müssen diese für eine bessere Anwendersicherheit aufgesteckt bleiben und stellen eine Prüfspitzenlänge von 4mm zur Verfügung.Diese Prüfleitungen besitzen einen anderen 4 mm Stecker mit Dichtring, da diese Prüfleitungen speziell für wasserdichte Multimeter (P 3355, P 3360, P 3443, P 3444, P 3445) geeignet sind.

€4.00*

«PeakTech® TKS-2» Test Leads with 2 mm probe tip
This test cable set for multimeters consists of safety test leads in accordance with the EN 61010-031 standard with 4 mm safety sockets in a robust design with a cable length of 120 cm and 90 ° angled plugs. The test probes length of the TKS-2 cables are limited to 2mm for the best possible user safety when used in CAT III and CAT IV environments.

€3.30*